![interlok driver setup winxx.exe interlok driver setup winxx.exe](https://img.yumpu.com/17974666/1/500x640/programming-with-step-7-manual-dce-fel-cvut-v-praze.jpg)
On Windows, only one process at a time can open a hardware resource like a "COM port". You need to find out what it is and close it. If, in step #4 above, Win500 indicates that the COMxx port is "already open", then some running program on your system has opened that COM port.
#Interlok driver setup winxx.exe serial#
![interlok driver setup winxx.exe interlok driver setup winxx.exe](https://i.ytimg.com/vi/4u3ao_dGhzw/maxresdefault.jpg)
I had tried everything else on iLok's support website, including doing a Windows 'repair' install, but this loophole turned out to be the only solution.
#Interlok driver setup winxx.exe serial number#
Under "Configuration -> Programming cables.", I see one cable listed: serial number "GRE-0412". When I launch Win500.EXE, it is able to communicate with the cable with no problems. I run this version on Windows XP Professional SP3, Windows Vista Ultimate (32-bit), Windows Vista Ultimate (64-bit), and Windows 7 Ultimate (64-bit). This screenshot was using two scanners, the top with tag the bottom without and taken simultaneously.Ĭlick to expand.I am running that same driver: Version 2.08.02 from FTDI I installed the "setup executable" via the link in the Comments column. Top is after alpha tagging bottom ARID: 106. So you may hear him with another ARID: #. Keep in mind, this cop has two radios, HH and car. BTW, should another RID initiate the call and he hesitates in reply, when he does finally key up-his unit number will appear. Then the next time Police Unit 201 initiates a call on any TG his ID will be on bottom line of display instead of ARID: #. Stop Remote, go to TGRP section of the TSYS, then Alpha Tag (replace) ARID: 624142 with the Unit number. If you write down the users Unit # when ARID appears and write this RID # next to unit number. ARID: 624142 (used twice) would have a TG also. Had you also checked Auto-create new TGRP's from Wildcard hits a talkgroup would have appeared also with the ARID entry in your image E.g. Click to expand.You've checked "Auto-create new Talkgroups from RID's".